The short answer
The Olympus OM-1 meter was designed for one 1.35V mercury cell, sold as PX625, PX13 or MR-9. Mercury cells are no longer made. Outside the Shot and ausgeknipst both list the same three names for the same cell.
The battery only runs the light meter. Outside the Shot points out that the shutter is mechanical, so the camera fires at every speed with no battery at all. You need a cell only if you want the built-in meter.
The best simple fix is a 1.35V Wein MRB625 zinc-air cell. It drops straight in at the right voltage. If you want something you don’t have to replace every couple of months, a proper MR-9 adapter with a silver-oxide cell is the long-term answer.
Why the voltage matters
The OM-1’s meter was set up for a cell that held a steady 1.35V. Today’s cells of the same size are 1.5V (alkaline) or about 1.55V (silver oxide). Put one in an unmodified OM-1 and the meter reads wrong.
Ausgeknipst explains the direction: too much voltage gives underexposure, too little gives overexposure. Negative film copes better with overexposure than under, so a meter that errs high is the worse problem.
How big the error is, sources disagree:
- Outside the Shot says silver oxide will “slightly underexpose,” and a fresh alkaline cell can underexpose by up to 2 stops.
- Ausgeknipst says some owners see 1/3 to 2/3 stop underexposure even at about 1.4V.
- A Photrio poster had read that 1.5V throws the meter out by about 3 stops. Another warned that the error changes with the light level, so a fixed ISO offset won’t correct it everywhere.
The safe advice: whatever cell you use, compare the OM-1’s needle with a phone meter app or another camera at a few light levels before you trust it.
Your options
| Option | Voltage | Life once in use | Notes |
|---|---|---|---|
| Wein MRB625 zinc-air | 1.35V | About 2 months (Outside the Shot) | Drop-in. Pull the tab to activate. Harder to find and a little dearer. |
| 675 hearing-aid cell in an adapter or O-ring | About 1.4V | 2–3 months (ausgeknipst) | Cheapest. Smaller than a 625, so it needs a spacer to make contact. |
| MR-9 adapter + 386/SR43 silver oxide | 1.35V (adapter drops it) | Long, cheap cells | Buy a real one. Outside the Shot warns many knock-offs are just holders with no electronics. |
| Schottky diode fitted inside | Drops about 0.15V | Use SR44 forever | Outside the Shot describes soldering it to the battery wire under the bottom plate. A job for a repairer. |
| 1.5V cell + ISO correction | 1.5–1.55V | Long | Unique Photo suggests setting the ISO about two stops lower. Check against another meter. |
Zinc-air cells need air. Once the tab is off, they start running down whether you use the camera or not. Ken Rockwell’s measurements show a Wein cell takes a minute or so to reach full voltage after activation, then holds about 1.4V for months. Ausgeknipst advises taking a zinc-air cell out after three months at most.
MR-9 adapters vary. A Photrio poster notes that a full overhaul by a specialist can include a built-in diode, so the camera runs on modern cells with no adapter at all.
How to check the battery
Press the battery check button. Outside the Shot says the needle should move to the BC mark. If it doesn’t, replace the cell. Ausgeknipst notes that a freshly activated zinc-air cell can read borderline for a short while before it settles.
Storage
Outside the Shot recommends removing the battery if you won’t use the camera for a while. If you find corrosion, it suggests cleaning the contacts with distilled white vinegar, then rubbing alcohol. Zinc-air cells should come out anyway once they’re spent.
Does the OM-1n take a different battery?
No difference is listed. Wikipedia describes the OM-1n’s changes as a redesigned advance lever, a flash-ready LED in the finder and automatic flash sync. The battery and meter are the same as the OM-1.
Other cameras with the same problem
The PX625 problem isn’t unique to Olympus. Our mercury battery replacement guide covers the same fixes for the Canon FTb, Minolta SRT 101, Olympus 35 RC, Canonet QL17 and others. The later Olympus OM-2 uses two SR44 cells and avoids it.
FAQ
What battery does the Olympus OM-1 take? A 1.35V PX625 (also called PX13 or MR-9) mercury cell, now discontinued. Use a Wein MRB625, a 675 zinc-air cell in an adapter, or an MR-9 adapter with a silver-oxide cell.
Can I use an LR44 or SR44 in an OM-1? They’re the wrong size and voltage on their own. In an adapter without voltage reduction, expect the meter to underexpose. Check it against another meter.
Does the OM-1 work without a battery? Yes. The shutter is mechanical. Only the meter needs power.
How long does a Wein cell last in an OM-1? Outside the Shot says about two months once the tab is pulled.
Is an MR-9 adapter worth it? Yes, if you’ll use the meter for years and buy a genuine adapter with voltage-reducing electronics. Cheap look-alikes are just holders.